2009 Jaguar XF Diesel
| Price | -- | Production | -- | ||
| Engine | 3 liter diesel V6 | Weight | -- | ||
| Aspiration | twin turbochargers | Torque | 443 lb-ft | ||
| HP | 271 hp | HP/Weight | -- | ||
| HP/Liter | 90.3 hp per liter | 1/4 mile | -- | ||
| 0-62 mph | 5.9 seconds | Top Speed | -- | 
(from Jaguar Press Release) THE NEW XF DIESEL S – In Brief
				
				
				
				
“With CO2 emissions of 
			179g/km, 42mpg average fuel economy and 0-60mph acceleration in 5.9 
			seconds, this is another great example of Jaguar delivering 
			unrivalled performance while at the same time taking the level of 
			refinement in diesel engines to a whole new level.”
			Mick Mohan, Jaguar Programmes Director
			
			When it was introduced last year, the XF was recognised as a 
			dramatic expression of a bold new Jaguar design language. It also 
			soon became apparent that here was a car where the driving 
			experience exceeded the expectations created by the striking 
			appearance. Now, the new XF Diesel S takes this driving experience 
			to new levels, shifting the balance even further towards dynamic 
			performance while still retaining the XF’s core values as a refined 
			and luxurious sports saloon. 
			
			Distinguished by discreet ‘S’ badging, the car that defines Jaguar 
			sporting luxury is even better for the 2010 model year, with a 
			stunning new high-performance diesel. Powered by a 275PS engine, the 
			Diesel S gives the XF outstanding levels of performance, 
			accelerating from 0-60mph in just 5.9 seconds, 1.8 seconds quicker 
			than the excellent 2.7-litre model. In-gear acceleration is equally 
			impressive, with a 50-70mph time of just 3.2 seconds. Maximum speed 
			is electronically limited to 155mph. 
			
			Featuring parallel sequential turbochargers to help deliver the high 
			levels of power and torque seamlessly and with effortless 
			flexibility, this engine is perfectly matched to Jaguar’s 
			sophisticated six-speed ZF 6HP28 automatic transmission.
			
			“The new parallel sequential turbocharger system on our new V6 
			diesel delivers V8 levels of performance from very low revs. It’s a 
			power unit that offers superb flexibility and remarkably low fuel 
			consumption and emissions, while building on the refinement that has 
			become a trademark of our Jaguar diesel engines.”
			Ron Lee, Group Chief Engineer, Powertrain
			
			There is an equally impressive 240PS version of the new 3.0-litre 
			engine available too, which produces 16 percent more power and a 15 
			percent increase in torque over the 2.7-litre diesel, allowing the 
			XF to reach 60mph in 6.7 seconds. Its 50-70mph time of just 3.7 
			seconds is only fractionally slower than the 275PS Diesel S model. 
			Maximum speed is 149mph. And like the 275PS engine, these great 
			performance leaps are achieved with combined average fuel 
			consumption of 42.0mpg – an improvement on the 2.7-litre diesel of 
			over 10 percent – and a CO2 emissions rating of only 179g/km. 
			
			There are also significant trim and specification changes – 
			including many new features – and the introduction of a new 
			Portfolio derivative as part of the core range. For Jaguar and the 
			new 2010 model year XF, the high-performance diesel has truly 
			arrived. Pricing for the 2010 model year diesels – which will carry 
			a premium over the current 2.7 – will be announced shortly. 
			
			The acclaimed XF 2.7 Diesel has won several accolades, including in 
			the UK What Car magazine’s ‘Diesel Car of the Year’ and ‘Car of the 
			Year’, What Diesel magazine’s ‘Diesel Car of the Year’ and the 
			Association of Scottish Motoring Writers’ Best Diesel of 2008. 
			Additionally, the XJ 2.7-litre Diesel was also named Britain’s 
			greenest luxury car in the Environmental Transport Association’s 
			2008 Car Buyers Guide for the second year running.
THE NEW AJ-V6D GEN III ENGINE - IN DETAIL
Drawing on the experience gained in designing the original, acclaimed 2.7-litre engine, the new 3.0-litre AJ-V6D Gen III diesels demonstrate that it is possible to deliver improved performance, while reducing CO2 emissions and fuel economy. In the XF, the new engine produces 10 percent less CO2 than the 2.7-litre, while power has increased by 33 percent in Diesel S guise. As well as tackling CO2, the new 3.0-litre engines meet the forthcoming EU5 regulations, due to come into force at the start of 2011. And these great performance leaps are achieved with combined average fuel consumption in both models of 42.0mpg – an improvement on the 2.7-litre engine of 12 percent.
Twin-turbos – maximum efficiency, instant response
A key feature of the new 
			engine is the unique, parallel sequential turbocharger system, the 
			first of its type to be fitted to a V-engine anywhere in the world.
			
			Delivering high torque throughout the entire engine rev range, 
			improved throttle response and low CO2 emissions, the 
			twin-turbochargers work sequentially to deliver unrivalled response 
			and best-in-class torque – an impressive 61 percent more than the 
			2.7-litre diesel from 1500rpm – while packing a huge punch at higher 
			engine speeds.
			
			For most day-to-day driving, including motorway cruising, a 
			responsive, variable-geometry primary turbocharger does all the 
			work, while the smaller, fixed-geometry, secondary turbo is dormant, 
			saving energy and improving efficiency. When the engine revs climb 
			above 2800rpm, the secondary turbo is brought on line within 300 
			milliseconds, smoothly and seamlessly boosting the engine output 
			with no discernible turbo-lag or power-step. 
			
			Driving a turbocharger requires pressure from the exhaust, creating 
			pumping losses in the engine and increasing fuel consumption. To 
			alleviate this, valves under the control of the engine management 
			system isolate the secondary turbocharger both from the exhaust 
			stream and the engine inlet tract when it is not required. 
			
			Some twin-turbo systems rely on a smaller turbo for primary use, 
			only using a larger turbo when higher power is required. Though 
			effective, this has the disadvantage of raised exhaust pressure and 
			increased pumping losses. The Jaguar system uses a larger, 
			variable-geometry turbocharger more of the time, which not only 
			reduces pumping losses, but also improves fuel consumption and CO2 
			emissions.
			
			Jaguar engineers particularly focussed on the issue of turbocharger 
			‘lag’ at low engine speeds. The new AJ-V6D Gen III 3.0-litre diesels 
			significantly out-perform their rivals by delivering 500Nm of torque 
			in only 500 milliseconds from idle. 
Third-generation commonrail
A new commonrail 
			fuel-injection system delivers up to five injections on each cycle 
			at a pressure of 2000bar. Each injector tip is perforated by seven 
			holes through which finely atomised fuel is sprayed into the 
			cylinders. The high-pressure injection increases power, improves 
			economy and reduces both CO2 and particulate emissions. New, 
			third-generation high-speed piezo injectors allow up to five precise 
			injection events during each combustion cycle, minimising engine 
			combustion noise. 
			
			Piezo crystal ‘packs’ operate each injector by expanding when an 
			electric current is passed through them. They react virtually 
			instantaneously but can make a distinctive click when fired, which 
			can add to diesel engine noise at idle. The crystals in Jaguar’s new 
			injectors are fitted nearer the tip, meaning they are mounted deeper 
			inside the engine providing better sound insulation and quieter 
			operation.
			
			Another new feature of the third-generation fuel-injection system is 
			the metering mode. Traditional diesel commonrail fuel pumps 
			oversupply the injectors, with the surplus being returned to the 
			fuel tank. During this process, fuel temperature increases and 
			cooling it again consumes considerable amounts of energy. In 
			metering mode, the pump delivers fuel to the injectors only at the 
			rate required. Consequentially, there is no rise in fuel temperature 
			and no wasted energy. 
Compact, light and clean
The two cylinder heads, 
			with four valves per cylinder, are made from aluminium and the 
			cylinder block is made from compact graphite iron (CGI). The higher 
			tensile strength of CGI makes it possible to cast a smaller block; 
			some 80mm shorter than a conventional ‘grey’ cast iron equivalent.
			
			
			The new, water-cooled, exhaust gas recirculation system (EGR), 
			important for reducing pumping losses and emissions of NOX in a 
			diesel engine, is more efficient and consumes less power than the 
			2.7-litre unit. The valves that allow exhaust gas into the system 
			are located on the ‘hot side’ of the engine nearest the exhaust 
			manifolds; these valves never cool while the engine is running, so 
			there is no condensation of combustion deposits which occurs on 
			engines fitted with ‘cold side’ valves, hence the EGR system always 
			works at maximum efficiency. Since the EGR cooling is so effective, 
			exhaust gasses can bypass the system and return to the exhaust 
			pipes, allowing faster engine warm-up from start-up and reducing 
			emissions still further. 
			
			EU5 emissions regulations have been achieved ahead of the 2011 
			legislative timetable using conventional diesel oxidation catalysts 
			and diesel particulate filters (DPFs). NOX levels are reduced at 
			source through the combustion system design, the addition of the new 
			commonrail injection system and the new EGR system with by-pass. As 
			a result, specialised NOX exhaust after-treatment is unnecessary, 
			avoiding a potential cost and the need to use additional precious 
			metals in the exhaust system.
Remarkably quiet for a diesel
The CGI cylinder block 
			and new piezo injectors reduce combustion noise in the engine. 
			Multiple, precise injections of fuel on the combustion stroke also 
			reduce combustion noise and all engine covers including camshaft 
			covers, front covers and the sump have been optimised to subdue 
			radiated noise. Engine enclosures have been ribbed to minimise 
			radiated noise and the sump pan is manufactured from sound deadening 
			steel (SDS), comprising a polymer layer sandwiched between two 
			layers of steel.
			
			Internal friction, a major contributor to unnecessary fuel 
			consumption, has been addressed by careful optimisation of the 
			crankshaft, valves and pistons. All these features combine to make 
			the new Jaguar AJ-V6D Gen III engines amongst the quietest premium 
			diesels on the market.
A major step forward
With its parallel 
			sequential turbocharger system, third-generation commonrail fuel 
			injection system and fully optimised EGR system, the new 3.0-litre 
			AJ-V6D Gen III diesel sets new class standards when it comes to 
			power, response and refinement in the premium diesel segment.
			
			“The new XF challenges the rules and redefines Jaguar sporting 
			luxury. Our designers and engineers have worked together to develop 
			elegant, inspired solutions to complex technical challenges. It’s a 
			simple but very effective philosophy and the result is great new 
			products like the new 3.0-litre diesel XF.” 
			Mike O’Driscoll, Managing Director, Jaguar Cars



